KANTECH KT 300 PDF

The Combus is a communication protocol that is integral to the KT It uses a four-conductor cable bus to which several expansion modules can be. Controls two doors and easily links to a network Update firmware directly from system workstation Fast operation, up to , baud Ready to go, no DIP. KANTECH SYSTEMS | KT/K Door Controller, 2-Reader, Kilobyte, ” Length x 3″ Width x ” Height, With Accessory Kit, Metal Cabinet with .

Author: Kishura Groll
Country: Chad
Language: English (Spanish)
Genre: Literature
Published (Last): 13 September 2015
Pages: 213
PDF File Size: 20.77 Mb
ePub File Size: 19.18 Mb
ISBN: 536-3-86287-842-3
Downloads: 33660
Price: Free* [*Free Regsitration Required]
Uploader: Mazugar

Case Study – MC Assembly.

Kantech KT-300 Installation Manual

Connect the battery leads to the battery, and connect the AC transformer. It does not seem to be communicating with the software. I am having a similar problem with a kt being connected via USB. KT CABmounted in a dry, secure location. kantch

I am having issues with it. KT Door Controller The KT door controller supports up to two readers, which can be installed either on a single door to monitor both entry and exit or on two separate doors. Posted May 30, If a device operates only by AC power, any interruption, however brief, will render that device inoperative it it does not have power. Don’t show me this message again.

  EEN VLUCHT REGENWULPEN PDF

Kantech Kt 2 Door Controller kb Memory Metal Cabinet | eBay

Table of Contents Pre-Installation Information Kt Compliance Specifications Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 of UL, fifth edition. If the lithium battery stops working, return the circuit board to Kantech.

In the event of a power surge or transient, a module may lock up and cease to communicate with the controller. Make an earth ground connection to the cabinet of the KT as per the requirements of your local electrical code.

Not all products include all features. Their tech support is extremely helpful.

Kantech kt – General Access Control Discussion –

Become a hattrix end user. This method uses existing kanttech for data exchange between EntraPass and the controllers. Page 4 Installation and Wiring Share this post Link to post Share on other sites. By pressing ‘print’ button you will print only current page.

Table of Contents Add to my manuals Add.

How do I assign it? A set fee which Kantech has pre- determined and which may be revised from time to time will be charged for each unit repaired. Do not connect the power until all wiring is completed.

  ENCOFRADOS DOKA PDF

Can be expanded up to 16 controlled outputs when using a KT-PC module. Kantech will not accept any shipment whatsoever for which prior authoriza- tion has not been obtained. Products which Kantech determines to be repairable will be repaired and returned.

Posted July 3000, Built-in Combus expansion means that relay, input, and output modules can be added to connect HVAC systems, elevators, motion detectors, and more. Product offerings and specifications are subject to change without notice.

I have set the baud rates to be the same on the port and in the software and I have the correct serial. Overview Power outputs are supervised and individually protected against short-circuits and surges by self-resetting PTC. By continue to navigate through this site or by clicking Approve, you consent to the use of cookies on your device as described in our Privacy Notice. Since the KT only supports mA, a power supply module can be 3300 to provide an additional 1 A to the Combus.